Honeywell THOR VM1 User Manual page 26

If the Thor VM1 is Full On, a press of the power button can be configured to put the unit in Standby. See the
(page 5-19) tab of the Power control panel.
StandbyMode
When the standby timer expires without a primary event occurring, the Thor VM1 transitions to Standby mode. Press-
ing the Power button exits Standby mode and transitions the Thor VM1 to Full On.
When in Standby mode, the status LED:
• blinks green very slowly if external power is attached.
• is off if external power is not attached.
System Standby Wakeup Events
The following event transitions the Thor VM1 from Standby to Full On Mode:
• Pressing and releasing the Power button
Hibernate Mode
When the Thor VM1 enters hibernate mode, all LEDs are off. Pressing the Power button returns the Thor VM1 to Full
On.
When in Hibernate Mode, the status LED:
• blinks green very slowly if external power is attached.
• is off if external power is not attached.
System Hibernate Wakeup Events
The following event transitions the Thor VM1 from Hibernate to Full On Mode:
• Pressing and releasing the Power button.
Off Mode
By default, the Thor VM1 turns off if the user presses the power button when the Thor VM1 is On. This behavior can be
configured on the
The Thor VM1 is also off when it is not connected to a power source and the UPS battery is depleted. However, an
internal Real Time Clock (RTC) powered by an internal battery maintains the date and time while the Thor VM1 is off.
3 - 4
Advanced (page 5-19) tab of the Power control panel.
Advanced