Honeywell THOR VM1 User Manual page 58

Manual Control Wiring Diagram
Ignition wire must be left unconnected Standard must be selected from the
Existing Circuitry On Vehicle
Fuse - See
Warning
statement below
CAUTION
For battery powered vehicles:
• Red wire is connected to battery positive. If there is a red wire and a red/white wire, twist them
• Black wire must be connected to battery negative. If there is a black wire and a black/white wire, twist
• Green wire must be connected to the vehicle chassis ground.
For internal combustion engine powered vehicles:
• Red wire is connected to battery positive. If there is a red wire and a red/white wire, twist them
• Black wire must be connected to battery negative. If there is a black wire and a black/white wire, twist
• Green wire is connected to the vehicle chassis ground, which can also be battery negative.
WARNING
For proper and safe installation, the input power cable must be connected to a fused circuit on the ve-
hicle. If the supply connection is made directly to the battery, the fuse should be installed in the positive
lead within 5 inches of the battery's positive (+) terminal. Use VM3055FUSE (or equivalent) to install the
fuse as shown below:
• For 12VDC input, use the 10A fuse from the kit or a slow blow fuse that has a DC voltage rating
• For 24VDC input, use the 6A fuse from the kit or a slow blow fuse that has a DC voltage rating greater
• For 36VDC input, use the 4A fuse from the kit or a slow blow fuse that has a DC voltage rating greater
• For 48VDC input, use the 3A fuse from the kit or a slow blow fuse that has a DC voltage rating greater
Note: For North America, a UL Listed fuse is to be used.
4 - 36
Battery
Main Switch
+Vo -Vo
See Caution statement below
together and connect to battery positive.
them together and connect to battery negative.
together and connect to battery positive.
them together and connect to battery negative.
greater than 12VDC.
than 24VDC.
than 36VDC.
than 48VDC.
AutoOn
Cable for optional
screen blanking
connection
Red/White (if present)
Red
Black/White (if present)
Black
Green
Blue
(not connected)
(page 5-5) control panel.
Quick Mount
Smart Dock
COM1 or COM2
Connector
Circular
Power
Connector