Adjusting The Presser Foot Lifter Sensor - ELNA 8300 Service Manual

Model 8300

Adjusting the Presser Foot Lifter Sensor

Adjust the presser foot lifter sensor after replacing the presser lifter sensor or circuit
board A.
Main
Slave
Brightness Foot UD
Card / USB PH Sensor
Solenoid
Bobbin
Tension releas lever
1
2
DC1
Sensor Off
Aging
Solenoid Hold
BobbinCheck
Switch bracket
Setscrew (A)
Tension release plate
1 Remove the top cover. (See page 3)
2 Turn the power switch on while pressing the Start/Stop
button. Do not release the button until the LCD screen
shows the adjusting mode.
1 Power switch
2 Start/stop button
3 The LCD screen will show the adjusting mode.
3
3 Adjusting mode
4 Press the "Foot UD" key.
5 Loosen the screw (A).
Move the switch bracket to adjust its position so that the
LCD screen shows "H" when the foot is raised and
shows "L" when the foot is lowered.
6 Press the "OK" key.
7 Turn the power switch off and then attach the top
cover.
34