Adjusting Thread Cutter Solenoid - ELNA 8300 Service Manual

Model 8300
The standard clearance between the plunger and the thread cutter solenoid should be 2.0 mm.
w

Adjusting thread cutter solenoid

e
q
1 Remove the belt cover and base (see page 6, 7).
2 Adjust the clearance between the plunger and the
thread cutter solenoid q by moving the thread
cutter solenoid setting plate .
3 Tighten screws w.
4 Attach the belt cover and base.
q Thread cutter solenoid
w Screws
e 2.0mm
30