Model 8300
Replacing Threader Plate and Adjustment
If the hook on the threader plate is damaged, replace it by following the instructions below.
Fig. 1
If the hook on the threader plate is not aligned with needle eys, adjust it by following the
instructions below.
A
View-X
Fig. 3
F
C
B
A
Fig. 2
(X)
E
To replace (Fig. 1):
1. Remove the presser foot.
2. Push down the Threader supporter plate
remove from the Pin
3. To attach the threader supporter plate, match the
groove of the Threader supporter plate
pin
B
,and then push it up to insert.
A
Threader supporter plate
B
Pin
C
Hook
Adjusting threader plate position (Fig. 2):
1. When the Hook
eye, loosen Screw
as shown.
D
If the hook position is too high or too low (Fig. 3):
1. Remove the face cover.
2. If the hook is too high, loosen the Screw
lower the Setting position plate
If the hook is too low, loosen Screw
the Setting position plate
19
B
. (Fig. 1)
C
is slightly touching the needle
D
and adjust the Threader plate
F
.
to slide up
E
F
.
A
to
A
with the
E
and