Table of Contents
Advertisement
Model 8300
Changing External Parts (5) Base Unit
A
9
C
A
8
B
A
Base
To remove:
1. Remove the Belt cover. (See page 4)
2. Remove Setscrew
the base unit .
3. Remove the X-Motor Connector
8
Connector
from the printed circuit board "A".
B
Joint bosses
8
Y-motor connector (White)
9
X-motor connector (Blue)
To attach:
4. Attach the X, Y-Motor Connectors
the printed circuit board "A".
5. Insert the X, Y-Motor Cords between the printed
cuircuit board "A" and Arm. Be sure the cords
are not caught between the Joint Bosses
the arm and base. Tighten Screws
temporarily.
B
Joint boss
6. Attach the Extension (Accessory) table
C
Extension table (Accessory)
A
7. Tighten Screws
table, base unit and free Arm.
Note: Attach the embroidery hoop with the template
on the carriage. Check the needle drop posi
tion against the template.
8. Attach the belt cover.
7
A
(4 pcs.), and remove
9
and Y-Motor
,
into
8
9
B
A
(4 pieces)
C
.
while aligning the extension
of
Hide quick links:
Advertisement
Table of Contents
