Adjusting Height Of Embroidery Foot P - ELNA 8300 Service Manual

Model 8300

Adjusting Height of Embroidery Foot P

Attach the Foot (P), and the space between the needle plate and the bottom surface of the
Foot (P) should be 1.0 to 1.6 mm, when the needle bar is at its lowest position.
D
E
F
C
B
A
1. Remove the face plate and top cover unit.
(See page 3)
2. Remove the face plate unit. (See page 3)
3. Lower the Needle
4. Insert the 1.2 mm Feeler gauge
the Embroidery Foot (P)
5. While pressing the Presser bar actuator
against the upper shaft cam, loosen the Screw
and push it down in the direction of arrow, then
tighten Screw F
6. Reattach the face plate and top cover.
22
and lower the presser foot lifter.
A
B between
and the Needle plate
C
again.
.
D
E down