Replacement And Adjustment Of The Needle Threader Plate - ELNA Elnita ec 30 Service Manual

REPLACEMENT AND ADJUSTMENT OF THE NEEDLE THREADER PLATE

If the hook of the threader plate is damaged, change and adjust the part as follows:
TO CHANGE THE THREADER PLATE:
1. Push down the needle threader knob and pull the threader plate supporter down to remove it (see FIG 1).
2. To install the needle threader plate, line the groove up with the pin and push it up to snap fit.
TO ADJUST THE THREADER PLATE POSITION:
3. If the hook on the threader positioning plate touches the top or bottom side of the needle hole, loosen
hexagonal socket screw and adjust the hook position (FIG.2).
4. If the hook on the threader plate touches the left or right side of the needle hole, loosen setscrew and adjust
the hook position (FIG 3).
FIG. 1
Replacing the threader plate supporter
(with the threader plate attached)
Pin
FIG. 2
Vertical adjustment
MECHANICAL ADJUSTMENT
Threader plate supporter
Threader
positioning
plate
Hexagonal socket screw
Adjustment of left or right direction
View from "X"
Nut
Threader plate
17
FIG. 3
Setscrew
X