Elna International Corps. SA
Replacement and Adjustment of Needle Threader Plate
To replace:
Pry out the threader plate holder with a screwdriver while pushing and holding the threader knob
(See fig. 1.).
Align the groove on the new threader plate holder with the pin (B) on the threader shaft. Push the
threader plate holder (C) up until it snaps in place.
Adjustment procedure:
1. If the threader hook thrusts or hits against either left or right edge of the needle eye: Loosen
the setscrew (E) and adjust the position of the threader plate (H) (See fig. 2).
2. If the threader hook thrusts against either top or bottom edge of the needle eye, or misses the
needle eye: Remove the face cover and loosen the setscrew (F). Move the threader position
setting holder (G) up or down to adjust the hook position.
3210 / 3230
Page 25
Service manual