Replacing Threader Plate And Adjustment - ELNA 9500 Service Manual

9500

Replacing Threader Plate and Adjustment

If the hook on the threader plate is damaged, replace it as follows.
q
VIEW-X
w
VIEW-X
Needle
w
To replace:
1 Remove the foot holder.
2 Turn the power switch "ON". Raise the needle
3 Lower the threader while pushing the threader
4 Turn off the poawer switch.
5 Loosen screaws (2pcs)(A) and replace the threader
Adjustment procedure:
1. If the threader hook
e
(A)
2. If the threader hook
r
(B)
28
while pressing the needle up/down button.
q
button .
w
plate .
e
left or right edge of the needle eye: Loosen Screws
(A) and adjust the position of the threader plate
e
bottom edge of the needle eye, or misses the needle
eye:
Remove the face cover and loosen Screw (B). Move
the Threader position adjusting holder (G)
down to adjust the hook position.
thrusts or hits against either
thrusts against either top or
r
up or
w .