Replacement And Adjustment Of Needle Threader Plate - ELNA 6125QC Service Manual

Replacement and Adjustment of Needle Threader Plate

To replace:
Pry out the threader plate holder with a screwdriver while pushing and holding the threader knob (See fig.
1.).
Align the groove on the new threader plate holder with the pin (B) on the threader shaft. Push the threader
plate holder (C) up until it snaps in place.
Adjustment procedure:
1. If the threader hook thrusts or hits against either left or right edge of the needle eye: Loosen the setscrew
(E) and adjust the position of the threader plate (H) (See fig. 2).
2. If the threader hook thrusts against either top or bottom edge of the needle eye, or misses the needle eye:
Remove the face cover and loosen the setscrew (F). Move the threader position setting holder (G) up or
down to adjust the hook position.
Threader knob
Fig. 3
Mechanical Adjustment
Hook (D)
Threader position
adjusting holder (G)
Setscrew (F)
Threader plate holder
Threader plate
View-X
27
Fig. 1
Pin
Fig. 2
Setscrew (E)
X
Hook (D)