Replacement And Adjustment Of The Needle Threader Plate - ELNA Star Edition Service Manual

REPLACEMENT AND ADJUSTMENT OF THE NEEDLE THREADER PLATE

If the hook of the threader plate is damaged, change or adjust the part as follows:
TO CHANGE THE THREADER PLATE:
TO REMOVE:
1. Push down the needle threader knob and pull the needle threader plate (A) down to remove it (see Fig. 1).
2. To install the needle threader plate, line the groove up with the pin (B) and push it up to snap fit.
TO ADJUST THE THREADER PLATE POSITION:
1. If the hook on the threader plate touches the left or right side of the needle hole, loosen setscrew (C) and adjust
the hook position (Fig. 2).
2. If the hook of the threader plate touches the top or bottom side of the needle hole, loosen setscrew (D) and adjust
the hook position (Fig. 3).
Threader knob
(Fig.3)
Setscrew (D)
MECHANICAL ADJUSTMENT
Needle hole
Position setting plate
Replacing the needle threader plate
(with the threader plate attached)
Hook
Threader plate
Nut
19
(Fig.1)
Pin (B)
Needle threader
plate (A)
(Fig.2)
View from "X"
Setscrew (C)
X