Replacement And Adjustment Of The Needle Threader Plate - ELNA 6200 Service Manual

REPLACEMENT AND ADJUSTMENT OF THE NEEDLE REPLACEMENT AND ADJUSTMENT OF THE NEEDLE REPLACEMENT AND ADJUSTMENT OF THE NEEDLE REPLACEMENT AND ADJUSTMENT OF THE NEEDLE REPLACEMENT AND ADJUSTMENT OF THE NEEDLE
IF THE HOOK OF THE THREADER PLATE IS DAMAGED, CHANGE OR ADJUST THE
PART AS FOLLOWS:
TO CHANGE THE THREADER PLATE:
TO CHANGE:
1. PUSH DOWN THE NEEDLE THREADER KNOB AND PULL THE NEEDLE THREADER PLATE (A)
OUT TO REMOVE IT (SEE FIG. 1).
2. TO INSTALL THE NEEDLE THREADER PLATE, LINE THE GROOVE OF THE THREADER WITH THE
PIN (B) AND PUSH THE PLATE UP TO SNAP FIT.
TO ADJUST THE THREADER PLATE POSITION:
1. IF THE HOOK ON THE THREADER PLATE THRUSTS OR HITS THE LEFT OR RIGHT SIDE OF THE
NEEDLE EYE, LOOSEN SETSCREW (C) AND ADJUST THE HOOK POSITION BY MOVING THE
THREADER PLATE (FIG. 2).
2. IF THE HOOK ON THE THREADER PLATE THRUSTS OR HITS THE TOP OR BOTTOM SIDE OF THE
NEEDLE EYE, LOOSEN SETSCREW (D) AND ADJUST THE HOOK POSITION BY MOVING THE
THREADER POSITION SET PLATE(FIG. 3).
THREADER KNOB
NEEDLE HOLE
ADJUSTMENT VERTICAL DIRECTION (FIG. 3)
THREADER PLATE THREADER PLATE
THREADER PLATE THREADER PLATE THREADER PLATE
HOOK
ADJUSTMENT IN HORIZONTAL DIRECTION
VIEW FROM X
SETSCREW
(D)
THREAD PLATE
THREADER
POSITION
SET PLATE
20
REPLACEMENT OF NEEDLE THREADER
PIN (B)
NUT
X
(FIG. 1)
THREADER PLATE (A)
SETSCREW (C)