Breaker Selection - Deif CGC 400 Installation Instructions Manual

CGC 400 installation instructions
4189340785 UK
Dig. input
CGC 400
Term. 5
Com
The binary inputs use fixed signals. Only the mode shift input and the test input (if the timer is
used) use pulse signal.

4.3 Breaker selection

4.3.1 Breaker selection
The controller can handle pulse, continuous and compact breakers. Selection of the breaker type is done in
the application configuration with the PC utility software. Output for breaker handling is chosen in the I/O con-
figuration of the PC utility software. In the table below is listed which outputs are needed for breaker handling
depending on the breaker type.
Breaker type
Pulse breaker
Continuous breaker
Compact breaker
The pictures below are examples of how to set up breakers.
DEIF A/S
GB on/MB on/TB on
X
X
X
GB off/MB off/TB off
X
X
Wiring
Page 13 of 25