Ricoh FT556 Service Manual page 60

5. Install the interface board [A] on the PCB
plate (2 screws, 1 connector).
6. Remove the sorter covers (2 screws each).
7. Mount the sorter on the copier. Insert the
two mounting studs into the docking holes,
and pass the harness through the access
hole.
8. Fix the sorter unit to the copier with two
knob screws and spacers [B].
When installing the duplex unit, the
spacers are not needed.
9. Connect the sorter adapter harness [C] to
the sorter (Free white 2P connector).
(non duplex machines only)
1-49