Tray Down Sensor And Positioning Switch Replacement - Ricoh FT556 Service Manual

2. TRAY DOWN SENSOR AND
POSITIONING SWITCH REPLACEMENT
1. Open the side cover.
2. Remove the top cover [A] and rear cover
[B] (5 screws).
3. Remove the sensor bracket [C] (2 screws).
(There is no need to disconnect the sensor
connector.)
4. Remove the two post tops [D] (3 screws
each).
5. Remove the tray
screws) taking care not to damage the 6
guide posts [F].
6. Move the tray drive motor assembly [G] (2
screws) to the rear to disengage the tray
drive shaft [H] from the wire drive pulley [I].
bottom plate [E] (4
3-53