Ricoh FT556 Service Manual page 25

31 March 1987
18. Connect the bank interface harness [A] to
the 3rd paper feed PCB [B] as shown.
19. Clamp the bank interface harness to the
bank docking bracket [C] with the large
nylon wire clamp [D] (1 screw with washer).
20. a. Connect the ac paper bank harness [E]
to the copier and clamp the harness with
the small nylon wire clamp [F] on the left
image plate of the PCB plate [G] as
shown (1 screw with washer).
b. When doing this step, run the harness
from the left side of the PCB plate so
that the rear cover may close properly.
Connect the 9P expansion interface har-
ness connector [H] to CN606 of the
paper feed PCB [I] and 2 free connec-
tors (8P [J] and 6P [K]) to free connec-
tors from the dc harness.
c. Fix the expansion interface harness to
the left hinge plate of the PCB plate with
the nylon wire clamp [L] (1 screw with
washer).
1-14