Ricoh FT556 Service Manual page 131

31 March '87
7. Remove the front terminal cover [A] (1
screw).
8. Unhook the fiber optics cable [B] from the
reflector cover [C] and remove the reflector
cover (2 screws).
9. Remove the leads to the exposure lamp
terminals [D].
10. Remove the auto ID sensor [E] and length
sensor [F] (1 screw).
Remove the width sensor [G] (1 screw).
11.
12. Remove the scanner harness [H] from the
1st scanner [I] (1 screw).
13. Slide the scanner to the right and remove
the female end of the exposure lamp power
supply harness [J] from the copier.
14. Remove the scanner harness from the har-
ness hold-down block [K] (1 screw).
15. Release the fiber optics cable from the
clamps [L], then remove it.
16. Slide the scanner to the left and remove
the lens housing cover [M] (3 screws).
Release the fiber optics cable from the
17.
clamps [N] in the optics cavity.
3-2