Ricoh FT556 Service Manual page 22

6. Remove the front [A] and rear [B] covers
from the expansion unit (2 screws each).
7. Adjust the height of the paper bank:
a. Remove the internal cover [C] from the
paper bank (2 screws).
b. Using the height adjusting bolts [D], raise
or lower the paper bank so that both the
front [E] and rear [F] screw holes of the
paper bank and expansion unit align.
c. Secure the paper bank to the expansion
unit (2 screws).
d. Open the system table front door [G],
swing out the 4th paper feed station [H],
and secure the paper bank to the front
side of the system table (1 screw).
e. Remove the bank rear cover [I] and the
bank rear right cover [J] (2
each), then secure the bank to the rear
side of the system table (1 screw).
f. Install the bank docking bracket [K] (2
screws).
g. Install the internal cover to the paper
bank (2 screws).
8. Install the front [L] and rear [M] expansion
docking plates as shown (2 screws each).
screws
31 March 1987
1-11