Using Light Shield to Digitize Industrial RT X-ray
Film
A light shield is a tool equipped in your MII-900 Plus, used to block out
unnecessary light when scanning. It can help to improve the dynamic range for
final scanned images. However, the maximum limit for the width of the Light
Shield is about 10.24 inches (26 cm). If the your scanned target is wider than
the maximum limit of the Film Shield, please do not use the Light Shield.
Attaching Light Shield into Guide Arms
Before using the Light Shield, you have to
fasten it into Guide Arms on the Input Tray.
Follow the steps below:
1. Locate the hook of the Light Shield at the
2. Slide the two Guide Arms toward the Light Shield. Align the Guide Arms
top of the front cover of the digitizer. Use
it to pull the Light Shield up.
Fastenings
with the Light Shield properly.
Hook
MII-900 Plus User's Manual
25