Digitizing Industrial Rt X-Ray Films In Other Sizes; Positioning Industrial Rt X-Ray Film - Microtek mii-900 plus User Manual

Digitizing Industrial RT X-ray Films in Other Sizes

If your scanned target cannot be used together with the Light Shield (wider than
10.24") or the supplied film holders, the MII-900 Plus also allows you to scan
various sizes of industrial RT X-ray films up to 14" x 52".

Positioning Industrial RT X-ray Film

MII-900 Plus's Feed Tray can hold only one piece of X-ray film at a time. This
section shows you how to position a single-sheet of X-ray film into the Feed Tray.
1. Install the Feed Tray onto your digitizer
2. Load and insert the film into the Feed
before using it. Refer to the front
sections "Installing the Feed Tray" for
the detail.
Tray, with the side to be scanned
facing up and with the top of the film
directing upwardly.
Push the film into the tray until the
edge of it touches the bottom edge of
the Feed Tray.
Make sure that the Light Shield has
been pull up.
Feed Tray
MII-900 Plus User's Manual 33