Digitizing Your X-Ray Film; Positioning Your X-Ray Film - Microtek Medi-7000 User Manual

Digitizing Your X-ray Film

Positioning Your X-ray Film

Medi-7000's Feed Tray can hold only one piece of X-ray film at a time. This
section shows you how to position a single-sheet of X-ray film into the feed tray.
1. Install the Feed Tray onto your digitizer
2. Load and insert the film into the Feed
3. Align the film with the center of the
24 Medi-7000 User's Manual
before using it. Refer to the front
sections "Installing the Feed Tray" for
the detail.
Tray, with the side to be scanned facing
up and with the top of the film directing
upwardly.
Push the film into the tray until the edge
of it touches the bottom edge of the Feed
Tray.
Feed Tray by sliding the two Guide Arms
toward the film if the width of the film is
less than 14 inches.
Feed Tray
Guide Arms