Using Light Shield To Digitize Industrial X-Ray Films; Attaching Light Shield Into Guide Arms - Microtek MII-900 Plus User Manual

Using Light Shield to Digitize Industrial X-ray
Films
The light shield is a tool equipped in your MII-900 Plus, used to block out
unnecessary light when scanning. It can help to improve the quality of the
scanned image. However, the maximum limit for the width of the Light Shield is
about 10.24 inches (26 cm). If the width of the scanned target is less than the
maximum limit of the Film Shield, push the Light Shield down; otherwise, pull the
Light Shield up and do not use it.
NOTE: When pulling up or pushing down the Light Shield, make sure it is set at
its proper position; otherwise, the system may detect that you are using a Multi-
Channel Tray falsely and then come out a waring message.

Attaching Light Shield into Guide Arms

Before using the Light Shield, you have to fasten it into Guide Arms on the Feed
Tray. Follow the steps below:
1. Locate the hook of the Light Shield at the top of the front cover of the
2. Slide the two Guide Arms toward the Light Shield. Align the Guide Arms
26 MII-900 Plus User's Manual
digitizer. Use it to pull the Light Shield up.
with the fastenings of Light Shield properly.
Guide Arms
Hook of the
Light Shield
Fastenings