Digitizing Your X-Ray Film; Positioning Your X-Ray Film - Microtek Medi-6000 Plus User Manual

Digitizing Your X-ray Film

Positioning Your X-ray Film

Medi-6000 Plus's Feed Tray can hold only one piece of X-ray film at a time. This
section shows you how to position a single-sheet of X-ray film into the Feed
Tray.
1. Install the Feed Tray onto your
2. Load and insert the film into the
3. Align the film with the center of the
digitizer before using it. Refer to
the front sections "Installing the
Feed Tray" for the detail.
Feed Tray, with the side to be
scanned facing up and with the
top of the film directing upwardly.
Push the film into the tray until
the edge of it touches the bottom
edge of the Feed Tray.
Feed Tray by sliding the two Guide
Arms toward the film if the width of
the film is less than 14 inches.
Feed Tray
Guide Arms
Medi-6000 Plus User's Manual 29