SATO CW408 Operator's Manual page 61

Preliminary
3.14 TEST PRINT MODE (Cont'd)
3.14.3 Configuration Test Print (User Test Print)
Printed Item Name
Print Speed
Print Darkness
Print Offset V
Print Offset H
Label Size
Operation Mode
Backfeed Action
Print Method
Sensor Type
OLED Sleep Time
OLED Brightness
OLED Language
Zero Slash
Codepage
Kanji Font
Character Pitch
Head Check
Head Check Mode
Auto Online
Initial Feed
Online Feed
Priority Setting
Command Error
Paper End Search
Buzzer
Option waiting time
Ignore CR/LF
Ignore CAN/DLE
Protocol Code
Printed contents of the interfaces will be the same as that of factory test print.
CW408 Operator Manual
2 to 6(inch/s)
1 (Lightest) ~ 10 (Darkest) A
±xxxx(dot)
±xxxx(dot)
(P)xxxx X (W) xxx (dot)
Continuous mode: Continuous
Cutter mode: Cutter
Dispenser mode: Dispenser
Tear-off mode: Tear off
After: Action 1
Before: Action 2
No backfeed motion: None
Direct thermal printing: Direct thermal
I-mark: Reflective sensor
Gap: Transmissive sensor
Sensor disabled: None
00 ~15 (min)
01 (dark) ~ 03 (bright)
ENGLISH/ CHINESE
Zero slash enabled: Enable
Zero slash disabled: Disable
858
GB18030
Printing by proportional pitch: Proportional
Printing by fixed pitch: Fixed
Disabled: None
Enabled:
Actual print area checking: Normal
Barcode print area checking: Barcode
1Item/ Page(xxxxxx)/ Start-End/ None
Enable/ Disable
Enable/ Disable
Enable/ Disable
Command/ Internal
Enable/ Disable
ROLL/ FANFOLD
Enable/ Disable
1000 (ms)
Enable/ Disable
Enable/ Disable
Standard/ Non-Standard
Printing out the protocol code set for the printer.
STX:xxH, ETX:xxH, ESC:xxH, ENQ:xxH,
CAN:xxH, NULL:xxH, OFFLINE:xxH, EURO:xxH
Section 3: Operation and Configuration
Description
Page 3-35