SATO CW408 Operator's Manual page 26

Preliminary
Section 2: Installation
2.4 HOW TO LOAD THE MEDIA (cont'd)
7.
Pull out the leading liner from the front side of the printer,
then pass the liner over the dispenser bar and under
the pressure bracket as shown.
8.
Close the pressure bracket firmly until a click sound is
heard.
9.
Close the top cover and press the two front corners of
the top cover until a click sound is heard. Make sure
that the top cover is locked.
Note:
Be careful not to get your fingers pinched while closing
the top cover.
When dispenser is installed on the printer
It is necessary to adjust the Offset position in the Adjustment screen. Refer to Section 3.4 Adjustment Mode
and Section 8.4.2 Adjustment of the Stop Position for details.
Page 2-12 CW408 Operator Manual