Operation Settings Mode - SATO CW408 Operator's Manual

Preliminary
Section 3: Operation and Configuration

3.9 OPERATION SETTINGS MODE

The following settings are available in the Operation settings mode.
LINE + FEED button
for more than 3 secs
LINE + FEED button
for more than 3 secs
LINE + FEED button
for more than 3 secs
LINE + FEED button
for more than 3 secs
LINE + FEED button
for more than 3 secs
1. In BASIC SETTINGS menu, press the LINE button repeatedly to display OP SETTINGS on the screen.
Press the FEED button to confirm the selection.
2. The OP SETTINGS menu is displayed. Press the FEED button to switch to the next setting options as
shown above. To return to the previous setting option, press the LINE and FEED buttons simultaneously.
To return to the BASIC SETTINGS screen, press and hold the LINE and FEED buttons simultaneously for
more than three seconds.
Page 3-16
BASIC SETTINGS
OP SETTINGS
SKIP SELECT
FEED button
LINE + FEED button
OP SETTINGS
OPERATION MODE
OP SETTINGS
TEAR OFF
OPERATION MODE
OP SETTINGS
CUTTER
OPERATION MODE
OP SETTINGS
DISPENSER
OPERATION MODE
CONTINUOUS
FEED button
LINE + FEED button
OP SETTINGS
BACKFEED MOTION
OP SETTINGS
BEFORE
BACKFEED MOTION
OP SETTINGS
NONE
BACKFEED MOTION
AFTER
FEED button
LINE + FEED button
OP SETTINGS
MEDIA TYPE
OP SETTINGS
FAN-FOLD
MEDIA TYPE
ROLL
FEED button
LINE + FEED button
OP SETTINGS
SENSOR TYPE
OP SETTINGS
GAP
SENSOR TYPE
OP SETTINGS
I-MARK
SENSOR TYPE
NONE
FEED button
LINE + FEED button
OP SETTINGS
BRIGHTNESS TIMER
00 MIN
FEED
button
* Press the LINE button to set the value or select an item.
* Press the FEED button to shift the cursor to the next digit or to
save the setting and move to the next screen.
* Press and hold the LINE and FEED buttons simultaneously for
more than three seconds to revert to the BASIC SETTINGS
menu.
When you installed the
cutter or dispenser, the
screen displays CUTTER
or DISPENSER respec-
tively.
These screens display only
when you have selected
CUTTER or DISPENSER
in OPERATION MODE.
NONE screen does not
display in DISPENSER
mode.
These screens do not
display when you have
selected DISPENSER in
OPERATION MODE.
NONE screen does not
display when you have
selected TEAR OFF or
DISPENSER in
OPERATION MODE.
CW408 Operator Manual