SATO CW408 Operator's Manual page 40

Preliminary
Section 3: Operation and Configuration
3.7 PRINT SETTINGS MODE (Cont'd)
Menu
PRINT SETTINGS
ADJUST SETTINGS
PRINT SETTINGS
PITCH ADJUST SETTINGS +0.00
PRINT SETTINGS
OFFSET ADJUST SETTINGS +0.00
DARKNESS 50
PRINT SETTINGS
PRINT SPEED
4 IPS
PRINT SETTINGS
PRINT DARKNESS
05
PRINT SETTINGS
PRINT OFFSET
V: + 0 0 0 0 H:+ 0 0 0
Print head
H+
Print
ref point 0,0
V+
V-
Page 3-14
PRINT SETTINGS MODE
Displaying the values of items set at the Adjustment mode.
PITCH: Shows the value of print offset position.
OFFSET: Shows the value of offset position.
DARKNESS: Shows the value of darkness setting.
Adjusts the print speed that does not compromise print quality.
The setting range is from 2 to 6 IPS (inches per second). When the optional
dispenser is installed, the setting range is from 2 to 4 IPS.
Press the LINE button to change the value with a increment of 1 IPS cyclically.
Press the FEED button to save the setting and proceed to the next screen.
The initial value is 4 IPS.
Note:
This screen displays only when "A" is set for DARKNESS RANGE of
ADVANCE SETTINGS.
This setting adjusts the print darkness of the printout with reference to the set-
ting of the DARKNESS in Adjustment mode.
Setting value can be set from 1 (lightest) to 10 (darkest). The initial value is 05.
Print Position Offset—which refers to the vertical and horizontal shifting of the
entire print area, relative to the start position of printing (V=0, H=0), defined by
default from the bottom right hand corner of the media.
The V setting is for the Vertical print offset. A positive (+) offset means the print-
ing is shifted towards the print head; a negative (-) offset means shifting away
from the print head. If the PITCH POSITION setting has been used to offset the
vertical start position, then all Vertical offset adjustments are made relative to
that start position.
H-
The H setting is for the Horizontal print offset. The + or - prefix determines
whether the offset is to the left or to the right of the reference point.
Setting range is as follows:
V:±0 to 3200 dots
The initial values are V:+0000, H:+000.
Press the LINE button to set the value and press the FEED button to shift the
cursor to the next unit.
Description
H:±0 to 832 dots
CW408 Operator Manual