Aastra DBC 225 Directions For Use Manual page 80

DBC 225 MX-ONE
FOR
7.3.4.2
7.3.5
7.3.5.1
7.3.6
80
Stop playing
The playing stops either when the # key is pressed or when the message
is ended. When the playing stops, the text message, Ready! , is
displayed. After that, you are allowed to either play, erase or record a
message.
Voice message erasing
Start message erasing
If the selected message is recorded, it is possible to erase the message
by pressing the procedure, 3*the message number#.
When the message is erased from the VSU board, the text message,
Ready! , is displayed. If the procedure fails to erase the message an
error message is displayed, see section Resume from fault conditions.
Resume from fault conditions
During the recording, playing or erasing messages, one of the following
fault conditions may occur:
Digit time out
Time out when an incomplete procedure is dialed. The inter-digit
time out duration is 15 seconds.
Message not stored
Attempt to play or erase non-recorded message.
4/1553-ANF 901 54 Uen D4 2014-01-14