Configuration Databases; Configuration; Dtm - Honeywell SLG 700 User Manual

2.1.4

Configuration Databases

The MC Toolkit is used to establish and/or change selected operating parameters in a Transmitter
database.
2.1.5

Configuration

Configuration can be accomplished both online and offline with the Transmitter powered up and
connected to the MC Toolkit. Online configuration immediately changes the Transmitter operating
parameters. For Offline configuration, Offline files created using Honeywell FDM Tool can be
imported into FDC application and then can be downloaded to the Transmitter.
When you set up or configure a Transmitter, it can take up to 30 seconds for the
value to be stored in it. If you change a value and Transmitter power is interrupted before
the change is copied to nonvolatile memory, the changed value will not be moved to
nonvolatile memory.
2.1.6 MC Toolkit–Transmitter Electrical/Signal Connections
Resistor values apply to SLG 700 Level transmitters only. Refer to SLG 700 Transmitter User's
manal, #34-SL-25-11, for acceptable power supply and RL ranges.
Figure 2 – MC Toolkit-Transmitter Electrical/Signal Connections
2.1.7

DTM

A DTM is supplied for use with PACTware .
See 7 Using DTMs
Page 4
SLG 700 Series HART Option User's Manual
Revision 5