Siemens SINUMERIK 808D ADVANCED Training Manual page 47

Commissioning
of Prototype
Machine using
Sample PLC
Commissioning the prototype
Drive optimization
The system will
automatically tune, using
the results of MX1 axis
high and low frequency
measurement as shown.
The axis optimization operation process will now optimise MZ1 axis of high
and low frequency measurement process. (a repeat of the 8 passes as
shown on previous page)
The system will
automatically tune, using
the results of MZ1 axis
high and low frequency
measurement as shown.
808D ADVANCED Turning and Milling
Step 9
Drive optimization
Drive optimization
After the full optimization
testing is completed, the
system will automatically
give a list of parameters
before and after optimiza-
tion of each axis data.
Press "activate"
SK makes the
data active.
Press "Next" SK to continue
The system will
automatically be
optimized after the
machine data is written to
the NC and drives.
Once successfully saved
the system will
automatically jump to the
next step "to establish the
machine debug file"
Page 47
s
Commissioning Guide