Siemens SINUMERIK 808D ADVANCED Training Manual page 27

Commissioning
of Prototype
Machine using
Sample PLC
Switching on and prepare for commissioning
4. Check that the status LED's on the front face of the V70 drives are in a
ready state.
V70 digital drive display at this stage, the status should be S - off.
For detailed information refer to :-
Commissioning manual page 81
Status on power up with Status on power up with
absolute encoder incremental encoder
Status description on SINAMICS V70
Item Description
8.8.8.8.8.8 Initializing the drive, will take 20 –30 sec
during the process
- - - - - - - Drive is busy
S - Off Operating display: servo off
r - 0 Drive is running properly
A 01...A 45 Alarm code
F 01...F 45 Fault code
808D ADVANCED Turning and Milling
Step 5
LED status indicators
Two LED status indicators (RDY and COM) are available to indicate drive
readiness status and communication status respectively.
Status LED's indicator
RDY
COM
Page 27
s
colour Status description
24v control board
- Off power supply is miss-
ing
Green Continuously lit Drive is ready
Enable signal is
Continuously lit missing or drive is in
Red start-up states
Flash at 1Hz Alarms or faults occur
Orange Flash at 2Hz Servo drive is located
Communication with
- Off
CNC is not active
Communication with
Flash at 0.5Hz
CNC is active
Green
SD card operating
Flash at 2Hz
(read or write)
Communication with
Red Continuously lit
CNC is in error
Commissioning Guide