Siemens SINUMERIK 808D ADVANCED Training Manual page 36

Hide thumbs Also See for SINUMERIK 808D ADVANCED:

Commissioning

of Prototype

Machine using

Sample PLC

Commissioning the prototype

Commissioning

PLC

The "connect status"

should now be green.

First the "Sample PLC blocks" should be uploaded to the PC, then the

modifications can be made to achieve the required functionality. Once this

has been completed, the PLC should be put into stop and the modified

PLC should be downloaded into the PPU. The PLC must then be

"restarted".

PLC Subroutines manual page 25

To continue press the SK

Commissioning Guide

Step 9

Check

I/O's

All I/O status must be checked with the electrical drawing using the

following SK's. The status is shown on the right hand side as shown

above.

Vertical SK's allow you to select digital inputs or outputs and selection of

the byte required.

Choose digital input

Choose digital output

Choose the digital O/I addresses of Byte -

Choose the digital O/I addresses of Byte +

Page 36

To continue press the SK

808D ADVANCED Turning and Milling