Siemens SINUMERIK 808D ADVANCED Training Manual page 42

Commissioning
of Prototype
Machine using
Sample PLC
Commissioning the prototype
Referencing
debugging
For detailed information
refer to :-
Commissioning manual
page 108
You can edit the axis machine data and the for the required axis.
Vertical SK's allow you to edit, activate or set as default
Used to select the axis (X or Z turn or X, Y, or Z mill)
Changes will be activated
MD set to default value
MD set to previous value
An axis can be referenced
To continue press the SK
Commissioning Guide
Step 9
Set spindle
parameters
For detailed information
refer to :-
Commissioning manual
page 110
The data below must be set as
default values:
Machine data Setting
30130 1
30240 2
0：output value is Bipolar
30134
1or2：output value is
Unipolar
0: without spindle encoder
30200
1: with spindle encoder
You can edit the spindle machine data required.
Vertical SK's allow you to edit, activate or set as default
Used to select the axis (X or Z turn or X, Y, or Z mill)
Changes will be activated
MD set to default value
MD set to previous value
Test spindle in MDA mode
Page 42
s
To continue press the SK
808D ADVANCED Turning and Milling