Advertisement
Software release notes for v1.76
The changes that differentiate versions 1.75 and 1.76 of the DV88/27 software:
• The DTS code has been fixed.
Version 1.75 of the software will not play disks with a DTS sound track.
Software release notes for v1.75
The changes that differentiate versions 1.74 and 1.75 of the DV88/27 software:
• Pluge (below black) menu item.
Until now, it has not been possible to perform a "pluge" test using the
DV88/27. A "Below Black" menu item has been added (to the bottom of
menu two), which has the options "Normal", for normal viewing of material,
and "Pass Pluge" for when the pluge test is being performed.
• FSEL lines now initialised.
The FSEL lines were not being initialised quickly enough previously, which
could lead to pops or crackles when the player was first switched on. This is
now fixed.
• Toggle-bit in remote codes.
The dependence on the toggle bit in our RC5 remote codes has been removed.
This means that the unit should be controllable using crappy learning remotes.
• "LOAD" brings the player out of standby.
Pressing the "LOAD" button on the front panel when the player is in standby
mode brings the player out of standby and opens the draw.
• CD skip-back works at 1 second.
It had been noted that the skip-back when a CD is being played did not work if
pressed at exactly 1-second into a track. This is now fixed.
• Single channel mono now available on analogue outputs.
Some VCDs have a different language on the left and right channels. A menu
option has been added ("Analog output", page 3) that allows the selection of
the left or right channel only (as mono output). Note that this setting applies
to the analogue output regardless of the disk type.
• Quicker initiation of digital output.
Previously, the AVR100/200 did not have time to synchronise with the digital
output before the audio starting, meaning that the first 2-seconds of audio may
have been lost. The digital output is now started 2-seconds before the audio
when CDs are played.
• CR9000 support.
The support for the CR9000 learning remote has changed.
The "arrow" keys must be reprogrammed to emit "arrows", not the commands
shown on the keys (such as "stop", "pause"), as previously.
• Clock output enable on progressive scan board.
The clock output has been enabled on the progressive scan board. This may
cause some boards to start working that previously did not.
•
Player must be reset after the self-test has been run.
After the self-test has been run, the player will accept no further input until it
has been reset.
L817SW release notes
Advertisement
