We do not advise the use of furniture cleaning sprays or polishes as they can cause indelible white marks if the unit is subsequently wiped with a damp cloth. DV88 PLUS 9. Power sources Only connect the appliance to a power supply of the type described in the operating instructions or as marked on the appliance.
Using this handbook This handbook has been designed to give you all the information you need to install, connect, set up and use the Arcam DiVA DV88 . The remote control handset supplied with the PLUS equipment is also described.
TV. AV control: The SCART output has a control signal that switches your TV to its SCART input when the DV88 will also signal to wide screen TVs the correct aspect ratio (16: 9 or 4:3), provided these features are supported by the TV.
DV88 PLUS To connect the progressive output of the DV88 follow the instructions above for connecting component video. If you are unsure whether your TV can accept progressive video, please refer to its instruction manual or consult your dealer.
In the ‘Setup’ menu, the that with the highlight bar at the bottom of the screen, pressing takes the bar to the top of the screen. DOWN DV88 PLUS button on the front panel. The power LED CD/DVD on the remote SETUP controls to highlight the item.
This informs the player which type of remote control you are using, so that the player can take into account the slight differences between the remote types. For ARCAM remote controls, the remote type is always written on the front of the remote control, normally at the bottom of the unit.
2-channel PCM. Note that the analogue output is muted when a DTS soundtrack is played, since DTS is not decoded. Prologic This item is not applicable for the DV88 changed. Audio delay This item is not applicable for the DV88 changed.
Should you need to navigate a disc or title menu from the front panel, use for ‘up’, for ‘down’ , PAUSE STOP ‘left’ and for ‘OK’. PLAY DV88 DVD PLAYER PLUS POWER PLAY on the front PLAY on the remote for ‘right’, DV88...
, then Standby Press to toggle the standby state of the DVD player. Standby Note that Arcam CD players are not controlled by this button. CLEAR CLEAR within the ‘Program’ and ‘Bookmark’ menus to clear a numeric field (see pages 12–13).
If this feature is available the ‘camera’ symbol lights in the display. Press to cycle through the available angles. ANGLE ‘Setup’ allows you to configure the DV88 use in your system. Ensure that no disc is playing and press SETUP MEM (memorise) It is possible to ‘bookmark’...
P MODE time. Peforming an A-B repeat The DV88 can repeat a specific section of a DVD or VCD; PLUS this is called an A-B repeat. To perform an A-B repeat, wait until the disc is at the point where you want the repeat to start, then press display shows a repeat symbol, followed by ‘A–’, and the front...
, then press PLAY . The ‘PROG’ indicator shows . To clear all the CLEAR . The ‘PROG’ indicator shows . To clear all the CLEAR button in the programme menu with PLAY DV88 PLUS...
Helpful messages to the user are displayed here. When the disc is loaded, the PAF button ( This means that loading the disc and pressing is enough to set the disc playing. DV88 PLUS Browse Disc Track 86:28:15 00:03:27...
CLEAR STOP PLAY button for a third time; this PROG button until the Repeat symbols button on the remote control to activate button for a second P MODE again P MODE DV88 PLUS...
2. Check battery compartment and reinstall batteries if necessary 3. Remove any obstruction 1. Select the video input on the TV to match the DV88 output (consult your TV handbook) 2. Check connections at both ends and, if necessary, try an alternative cable 1.
PCM/Dolby digital/MPEG/DTS on gold plated phono (coax) and TOSLINK (optical) CR-314 remote control 2 x AAA batteries mains lead Continual improvement policy Arcam has a policy of continual improvement for its products. This means that designs and specifications are subject to change without notice. DV88 PLUS...
This equipment should be packed in the original packing and returned to the dealer from whom it was purchased, or failing this, directly to the Arcam distributor in the country of residence. It should be sent carriage prepaid by a reputable carrier -– NOT by post.