Periodic Maintenance - Vent-Axia 405215 Advance S Installation & Commissioning Manual

Maintenance

Periodic Maintenance

THE FAN AND ANCILLARY CONTROL EQUIPMENT MUST BE ISOLATED FROM THE POWER SUPPLY
DURING MAINTENANCE.
Fan Filters
Check fan filters as described on the
previous page.
Heat Exchanger Cell
Step 1: Remove the outer cover by
pressing the tabs either side of the
control module and lifting the cover
outwards from the bottom edge.
Step 2: Remove the inner door by
undoing the 4 retaining screws.
Step 3: Slide the heat exchanger out
from the unit.
Wash the outer cover and heat
Step 4:
exchanger in warm water using a mild
detergent (such as Milton Fluid) and dry
thoroughly.
NOTE: Keep water away from all
electrical components and wiring
within the unit.
Motors
Inspect the motors for build-up of dust
and dirt on the impeller blades, which
could cause imbalance and increased
noise levels. Vacuum or clean if
necessary.
Condensate Drain
Check the condensate drain tube is
secure and clear of debris. Clean if
necessary. Ensure the trap is fully
charged with water.
Fastenings
Check that all unit and wall-mount
fastenings are sufficiently tight and have
not become loose. Re-tighten if
necessary.
42
WARNING
Sentinel Kinetic Advance MVHR Installation & Commissioning Instructions PN 408651