Commissioning; Powering Up The Unit; Overview; Control Unit Touch Screen Display - Vent-Axia 405215 Advance S Installation & Commissioning Manual

Commissioning

Powering up the Unit

Switching On
To switch the unit on:
1. Switch on the power at the mains supply isolator feeding the unit.
2. Following switch-on, the fan motors will start and the Control Unit will display a start-up screen,
described on page 22.
N.B. If you are intending to carry out work or maintenance inside the unit, switch off the power at
the mains outlet supplying the unit before you remove the covers.
Switching Off
To switch the unit off:
3. Turn the power off at the mains supply isolator.

Overview

The instructions in this section are intended to provide configuration and operation information for setting
up the equipment. In the event of problems, see Troubleshooting on page 44
Follow good practice when commissioning the unit. Ensure that the system is installed according to the
system designers intent incorporating any acoustic ducting, that all joints are air tight, ducting is well
supported, bends are avoided close to vents, and that the vent valves are fully open at the start of the
commissioning process.

Control Unit Touch Screen Display

The Control Unit is located at the front of the Sentinel Kinetic Advance unit. The Control Unit provides the
user interface for commissioning and monitoring purposes. The display is a resistive touchscreen with LED
backlight, which is turned off to automatically after 5 minutes to minimise power consumption.
User mode (Boost) button
Settings & Performance bar
Navigate through the functions by pressing the
buttons. A
option on the touchscreen to access the related screens.
Sentinel Kinetic Advance MVHR Installation & Commissioning Instructions PN 408651
Status bar
symbol indicates that there are further screens related to a menu option. Select the
Commissioning
symbols, adjust settings using the
21