Electrical Installation - Vent-Axia 405215 Advance S Installation & Commissioning Manual

Electrical Installation

Step 1: Remove the outer cover by
pressing the tabs either side of the control
module and lifting the cover outwards from
the bottom edge.
Step 2: Remove the control module by
lifting it upwards and away from the unit.
Step 3: Remove the two screws on either
side of the access panel. Lift the panel
outwards from the bottom edge to remove.
Note: The access panel is tethered on the
left hand side.
Note: All printed circuit boards are ESD
sensitive. Always ensure the correct ESD
protection is used (e.g. conductive wrist
straps and anti-static mats.)
Step 4: Push the locking tab away from
the printed circuit board and slide it
outwards to access the terminals
Note: The printed circuit board will relock
after 60mm
Sentinel Kinetic Advance MVHR Installation & Commissioning Instructions PN 408651
Installation
17