Connect Switches And Sensors - Vent-Axia 405215 Advance S Installation & Commissioning Manual

Installation

Connect Switches and Sensors

The unit can be switched to boost by a variety of methods:
Applying 240 V to the LS input .

Switching across 1 pair of switch terminals.

N.B Alternative switches and inputs can be achieved by adding optional input accessories to the
printed circuit board. See Accessories on page 6 for further details.
Connect any switches or sensors required to control the unit by connecting to the terminal connectors at
the bottom of the control unit as shown on Page 19 and in Table 1. If necessary contact Vent-Axia
regarding the wiring and fixing of accessories and sensors.
When fitting external controls, all cables should be routed through the two cable channels on the
underside of the unit shown below.
18
Figure 4: Sentinel Kinetic Advance cable channels
Sentinel Kinetic Advance MVHR Installation & Commissioning Instructions PN 408651