Electrical Installation - Vent-Axia Advance S Installation And User Manual

Electrical Installation

THE ENSURE THE ELECTRICAL SUPPLY AND CONTROLS ARE ISOLATED FROM THE POWER
SUPPLY BEFORE REMOVING ACCESS COVERS
Step 1: Remove the outer cover by
pressing the tabs either side of the control
module and lifting the cover outwards from
the bottom edge.
Step 2: Remove the two screws on either
side of the access panel. Lift the panel
outwards from the bottom edge to remove.
Note: The access panel is tethered on the
left-hand side.
Note: All printed circuit boards are ESD
sensitive. Always ensure the correct ESD
protection is used (e.g. conductive wrist
straps and anti-static mats.)
Step 3: Push the locking tab away from
the printed circuit board and slide it
outwards to access the terminals
Note: The printed circuit board will relock
after 60mm
MVHR Installation and User Guide 476930
11
WARNING
Installation