Replacing The Processor - Siemens SIMATIC IPC547D Operating Instructions Manual

Device maintenance and repair
7.1 Removing and installing hardware components
3. Disconnect all cables from the motherboard.
4. Remove the ten screws indicated in the following figure.
7.1.10

Replacing the processor

Requirement
● The device is disconnected from the power network.
● The device is opened.
● A suitable processor
74
Only an approved processor is permitted to be installed on the motherboard of the
device. If the processor type is changed, the BIOS must be updated so that the suitable
microcode is loaded. Information about original spare parts for SIMATIC IPCs is available
on the Internet at:
– After sales information system from SIMATIC IPC (http://www.siemens.com/asis).
– Contacts (http://www.siemens.com/automation/partner)
Operating Instructions, 06/2011, A5E03473780-01
SIMATIC IPC547D