Emerson Oxymitter 5000 Instruction Manual page 130

Model 4081FG Oxygen Analyzer with F
Parameter Index
Number
BLOCK_ALM 21
BLOCK_ERR 06
CHANNEL 15
FIELD_VAL 19
GRANT_DENY 12
HI_ALM 34
HI_HI_ALM 33
HI_HI_LIM 26
HI_HI_PRI 25
HI_LIM 28
HI_PRI 27
IO_OPTS 13
L_TYPE 16
LO_ALM 35
LO_LIM 30
LO_LO_ALM 36
LO_LO_LIM 32
LO_LO_PRI 31
LO_PRI 29
LOW_CUT 17
MODE_BLK 05
OUT 08
OUT_D 37
OUT_SCALE 11
PV 07
B-2
OUNDATION
Units
None The block alarm is used for all configuration, hardware, connection failure or system
problems in the block. The cause of the alert is entered in the subcode field. The first alert
to become active will set the Active status in the Status parameter. As soon as the
Unreported status is cleared by the alert reporting task, another block alert may be reported
without clearing the Active status, if the subcode has changed.
None This parameter reflects the error status associated with the hardware or software
components associated with a block. It is a bit string, so that multiple errors may be shown.
None The CHANNEL value is used to select the measurement value. Refer to the appropriate
device manual for information about the specific channels available in each device.
You must configure the CHANNEL parameter before you can configure the XD_SCALE
parameter.
Percent The value and status from the transducer block or from the simulated input when simulation
is enabled.
None Options for controlling access of host computers and local control panels to operating,
tuning, and alarm parameters of the block. Not used by device.
None The HI alarm data, which includes a value of the alarm, a timestamp of occurrence and the
state of the alarm.
None The HI HI alarm data, which includes a value of the alarm, a timestamp of occurrence and
the state of the alarm.
EU of PV_SCALE The setting for the alarm limit used to detect the HI HI alarm condition.
None The priority of the HI HI alarm.
EU of PV_SCALE The setting for the alarm limit used to detect the HI alarm condition.
None The priority of the HI alarm.
None Allows the selection of input/output options used to alter the PV. Low cutoff enabled is the
only selectable option.
None Linearization type. Determines whether the field value is used directly (Direct), is converted
linearly (Indirect), or is converted with the square root (Indirect Square Root).
None The LO alarm data, which includes a value of the alarm, a timestamp of occurrence and
the state of the alarm.
EU of PV_SCALE The setting for the alarm limit used to detect the LO alarm condition.
None The LO LO alarm data, which includes a value of the alarm, a timestamp of occurrence and
the state of the alarm.
EU of PV_SCALE The setting for the alarm limit used to detect the LO LO alarm condition.
None The priority of the LO LO alarm.
None The priority of the LO alarm.
% If percentage value of transducer input fails below this, PV = 0.
None The actual, target, permitted, and normal modes of the block.
Target: The mode to "go to"
Actual: The mode the "block is currently in"
Permitted: Allowed modes that target may take on
Normal: Most common mode for target
EU of OUT_SCALE The block output value and status.
None Discrete output to indicate a selected alarm condition.
None The high and low scale values, engineering units code, and number of digits to the right of
the decimal point associated with OUT.
EU of XD_SCALE The process variable used in block execution.
fieldbus Communications
Description