Before Commencing Repair Work - Danfoss VLT Micro Drive FC 51 Series Operating Instructions Manual

1 Safety
1.1.7 Disposal instruction
1

1.1.8 Before Commencing Repair Work

1. Disconnect FC 51 from mains (and external DC supply, if present.)
2. Wait for 4 minutes for discharge of the DC-link.
3. Disconnect DC bus terminals and brake terminals (if present)
4. Remove motor cable
8
Equipment containing electrical components must not be disposed of together with domestic waste.
It must be separately collected with electrical and electronic waste according to local and currently valid leg-
islation.
MG.02.A4.02 - VLT
®
VLT Micro Drive FC 51 Operating Instructions
®
is a registered Danfoss trademark