Table of Contents
Advertisement
1.4
System Requirements
To perform a NanoQuant measurement, the following items are required:
Infinite 200 Pro
•
An Infinite 200 Pro reader with firmware version V2.0 or higher
•
A computer with i-control V1.4 Service Pack 1 or higher installed
•
The NanoQuant Plate Package
Make sure the following absorbance filters are available on the filter slide of
your Infinite F200 PRO:
•
Position 1: 260 nm (5 nm bandwidth)
•
Position 2: 280 nm (3 nm bandwidth)
•
Position 3: 340 nm (10 nm bandwidth)
•
Position 4: free (for individual use)
For Infinite F200 PRO, the filter positions must remain in the order in which they
were delivered. The original filter positions guarantee the fastest filter switching
for well-wise measurements. The Infinite M200 PRO can be used immediately
for measurement without any calibration of the monochromator.
Infinite M1000, Infinite F500
•
An Infinite M1000 reader (REF 30061442) with main firmware version
V2.0 or higher
•
An Infinite F500
•
Software: i-control V1.8 or higher
•
The NanoQuant Plate Package
Make sure the following absorbance filters are available on the filter slide of
your Infinite F500:
•
Position 1: 260 nm (5 nm bandwidth)
•
Position 2: 280 nm (3 nm bandwidth)
•
Position 3: 340 nm (10 nm bandwidth)
Note
Only use the Infinite reader and the NanoQuant Plate at room temperature and
under normal laboratory conditions.
2013-06
Quick Guide NanoQuant Plate
TM
No.30035094 Rev No. 1.4
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the NanoQuant Plate and is the answer not in the manual?
Questions and answers