2.2.2
Removing SIMMs
Follow these steps when removing SIMMs:
1.
Press the holding clips on both sides of the SIMM outward to release it.
2.
Press the SIMM downwards at about 45
3.
Pull the SIMM out of the socket.
NOTE:
2.2.3
Reconfiguring the System
Reconfigure the system after installing or removing SIMMs.
Follow these steps to reconfigure the system:
1.
Reboot the system. A memory error message appears, indicating that
the total memory does not match the value stored in CMOS.
2.
Press Ctrl-Alt-Esc to run Setup.
A warning message indicating a wrong memory configuration appears.
3.
Press Esc twice to exit Setup and reboot the system.
The system boots with the new memory configuration.
Always remove the SIMM from the highest bank first.
angle.
o
System Board 2-7