Table of Contents
Advertisement
Hidden Refresh ------------------------------------------------------
CPU-DRAM Read Cycle Insert Wait ---------------------------
CPU-DRAM Write Cycle Insert Wait ---------------------------
SCSI I/O ROM Mapping -------------------------------------------
= Move Highlight Bar, = Change Setting, PgDn/PgUp = Move Screen
F9 = Default Setting, F10 = Bootable Setting, F1 = Help, Esc = Exit
*
The parameter values on the screens may not be the same as the
ones on your machine.
The default settings are the values initially stored in ROM. If in the future you
change these settings, you can load the default settings again by pressing F9.
When you add a component to the system, you may have to change some
settings. If the system does not boot, use the bootable settings to boot the
system. To do this, press F10 before you turn on the power and hold it until you
hear two beeps. The system then automatically sets the CMOS values to
bootable settings.
5-1 Owner's Handbook
Advanced System Configuration
Page 2
[Enabled ]
[Disabled]
[Disabled]
[0D0000H]
Advertisement
Table of Contents
