Nfc Module - HP Pro x2 612 G2 Maintenance And Service Manual

NFC module

Description
NFC module and antenna
IMPORTANT:
Before removing the NFC module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Keyboard (select products only) (see
b. Micro SIM card tray (see
c. MicroSD card tray (see
d. Rear cover (see
e. Disconnect the battery (see
f. Kickstand (see
g. SSD (see
h. Display panel (see
i. Battery (see
Remove the NFC module:
1. Remove the clear plastic tape (1) covering the NFC cable and the fingerprint reader board, and then
disconnect the cable from the fingerprint reader board (2).
2. Remove the clear plastic tape (3) securing the NFC cable to the middle frame.
NOTE:
Make special note of each screw size and location during removal and replacement.
Micro SIM card tray on page
MicroSD memory card tray on page
Rear cover on page
Kickstand on page
SSD on page 38)
Display panel on page
Battery on page
The tape can be reused.
Keyboard (select products only) on page
32)
34)
Disconnecting the battery on page
36)
45)
49)
Spare part number
918399-001
31)
33)
35)
Component replacement procedures 53