Kickstand - HP Pro x2 612 G2 Maintenance And Service Manual

Kickstand

Description
Kickstand
Hinges
IMPORTANT:
NOTE: There are a number of magnets located on the computer. The screws may attach to the magnets
after being unscrewed.
Before removing the kickstand, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Keyboard (select products only) (see
b. Rear cover (see
c. Disconnect the battery (see
Remove the kickstand:
1. Remove 4 Torx-5 screws (1) securing the hinges and kickstand to the computer.
2. Lift the kickstand to remove it (2).
36 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Make special note of each screw size and location during removal and replacement.
Rear cover on page
Disconnecting the battery on page
Keyboard (select products only) on page
34)
Spare part number
918394-001
918904-001
31)
35)