Nfc Antenna - HP ElitePad 1000 G2 Maintenance And Service Manual

NFC antenna

Description
NFC antenna
Before removing the NFC antenna, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display assembly (see
Remove the NFC antenna:
1. Release the ZIF connector (1) to which the NFC antenna cable is attached, and then disconnect the NFC
antenna cable from the system board.
2. Detach the NFC antenna (2) from the surface of the system board. (The NFC antenna is attached to the
system board with double-sided adhesive.)
3. Remove the NFC antenna (3).
Reverse this procedure to install the NFC antenna.
Display assembly on page
Tablet component replacement procedures
Spare part number
747633-001
28).
35